Synchronet v3.21e-Win32 (install) has been released (Mar-2026).

You can donate to the Synchronet project using PayPal.

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision		Previous revision
util:sexpots [2022/01/23 03:12] – [Configure] Document the Prompt (multiple host) feature digital manutil:sexpots [2024/06/09 21:37] (current) – [Modem Settings] Note about the factory defaults digital man
Line 118: Line 118:
 DTRDelay = 100              ; Milliseconds to delay before hangup DTRDelay = 100              ; Milliseconds to delay before hangup
 NullModem = FALSE           ; Set to TRUE to not send AT commands to modem NullModem = FALSE           ; Set to TRUE to not send AT commands to modem
 +Parity = FALSE              ; Use parity (error detection/correction) bit
 +ParityOdd = FALSE           ; Use odd (not even) parity for parity calculations
 +ByteSize = 8                ; Number of data bits per byte
 +StopBits = 1                ; Number of stop bits per byte
  
 [Modem] [Modem]
Line 153: Line 157:
 Note: Support for the ''[modem] ReInit'' key was added in SEXPOTS v1.27. Note: Support for the ''[modem] ReInit'' key was added in SEXPOTS v1.27.
  
 +==== Modem Settings ====
 +
 +Modem settings that SEXPOTS will work best with:
 +
 +^ AT Command ^ Description ^
 +| ''C1''     | Modem asserts the DCD signal when it makes connection with another modem and de-asserts the signal upon disconnect. |
 +| ''E0''     | Command echo from the modem is disabled. |
 +| ''Q0''     | Result codes are sent by the modem. |
 +| ''V1''     | Verbal result codes are sent by the modem (instead of numeric result codes). |
 +| ''W2''     | When connecting, the modem reports the line speed (just once) in the CONNECT message. |
 +| ''&C1''    | Modem asserts the DCD signal only when carrier is present. You will need to set ''IgnoreDCD = TRUE'' if your modem does not support this. |
 +| ''&D2''    | When the the DTR signal is de-asserted (on->off transition), the modem hangs up. |
 +| ''S2=43''  | Escape sequence character: ''+'' |
 +| ''S3=13''  | Carriage return character: ''^M'' |
 +| ''S3=10''  | Line feed character: ''^J'' |
 +| ''S95=3''  | CONNECT result code indicates DCE speed instead of DTE speed, append /ARQ in error-correction mode. ((for modems that support this S-Register)) |
 +
 +These are typically the default factory settings for modems manufactured in the last 30 years.
 +
 +If these settings are not your modem's factory defaults, then you may need to make adjustments to the modem initialization string or (if unsupported by your modem), make other adjustments to your configuration file or command-line options.
 ==== Prompting for a TCP Host ==== ==== Prompting for a TCP Host ====
  

Trace: