Synchronet v3.18b-Win32 (install) has been released (Sept-2020).

Synchronet v3.19a, now under development, requires libarchive-dev to build successfully.

You can donate to the Synchronet project using PayPal.

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
howto:binkd [2017/10/11 16:27]
nelgin [Multiple Zones] fine and dandy typo.
howto:binkd [2021/01/17 22:34]
ragnarok [SBBSecho] add fixme for old sbbsecho settings
Line 60: Line 60:
  
 **Tip:** Use ''​root-domain binkp.net''​ in your ''​binkd.cfg''​ file to enable IP address look-ups from a FidoNet node number (e.g. FidoNet address ''​1:​103/​705''​ can be resolved to an IP address using the hostname ''​f705.n103.z1.binkp.net''​). This used to be possible using the domains ''​fidonet.net''​ and ''​fidonet.org'',​ but not currently (use ''​binkp.net''​ instead). **Tip:** Use ''​root-domain binkp.net''​ in your ''​binkd.cfg''​ file to enable IP address look-ups from a FidoNet node number (e.g. FidoNet address ''​1:​103/​705''​ can be resolved to an IP address using the hostname ''​f705.n103.z1.binkp.net''​). This used to be possible using the domains ''​fidonet.net''​ and ''​fidonet.org'',​ but not currently (use ''​binkp.net''​ instead).
 +
 +**NOTE:** If root-domain is used, it applies to //all// FTNs listed. This is not proper if you are in more than one FTN because all f.n.z DNS lookups will go to this domain no matter what FTN they are. In the case of binkp.net, it only knows fidonet. Each FTN that provides DNS lookups for f.n.z format need their own DNS lookup host specified. So you should use the newer format of binkd'​s domain lines which place the DNS lookup host at the end of the line. At this time, there are only four FTNs that provide f.n.z DNS lookups. For all others, do not put anything in the "DNS lookup host" field of the domain lines. When using this form of domain line, be sure to remove or comment out any root-domain line you may have.
 +
 +eg:<file binkd.cfg>​
 +  #domain FTN      outbound dir  zone  DNS lookup host
 +  domain ​ fidonet ​ bP/​outbound ​  ​fZ ​   binkp.net
 +  domain ​ fsxnet ​  ​bP/​outbound ​  ​fZ ​   fsxnet.nz
 +  domain ​ scinet ​  ​bP/​outbound ​  ​fZ ​   scinet-ftn.org
 +  domain ​ vkradio ​ bP/​outbound ​  ​fZ ​   ftn.vkradio.com
 +</​file>​
 ===== SBBSecho ===== ===== SBBSecho =====
 +
 +FIXME - This howto show old sbbsecho config settings (must be update to new sbbsecho.ini format)
  
 Here's my ''​[[config:​sbbsecho.cfg]]''​ file with the same replacements as above: Here's my ''​[[config:​sbbsecho.cfg]]''​ file with the same replacements as above:

In Other Languages